Step By Step Building The Top Magnetic Generator Videos

The Magnetic Energy Generator is based on two metal Magnet Rotor Disks made of steel.
On this disk, there are already drilled four holes + 1 in the center.
These holes are required to mount the rotor to the hub.
Draw two lines connecting two opposite holes and then add two more lines, going through the central hole.
This way, you will divide the disk into eight equal parts.
Next, you’ll need to draw an inner circle on the disk.
Next, drill eight holes in the disk, each at the same distance from the other.
Finally, for this stage, you need to use a screw tap to tap the holes.

Take a piece of paper and place the disk on it.
Then cut the paper along the outer line of the disk.
Next, place the paper on the disk.
Place eight magnets on the paper at an equal distance.
Then cut the paper again along the outer line of the magnets.
Next, you make marks on the paper for the disk holes and make incisions with a chisel.
Then you will place a ring on the paper and cut the paper along the outer line. The paper is ready.

Take the disk and place a paper on it.
Place the outer mold on them.
Insert screws on the outer mold and the disk holes.
Place a ring on the disk and fix it with glue.
Next, place the eight magnets on the disk at an equal distance.
Fill in the gap with resin.
Place the paper between the faceplate and the stack.
Put the coil along the outer lines of the magnets.
Wait for the resin to dry, clean the plate, remove the ring and the screws from the outer mold.

Place the two magnet rotor disks side by side.
Insert the bearing hub between the two disks.
The permanent magnet motor is ready to use now.

As the magnets push and pull each other, depending on their positions north and south of each other, the disks will rotate and accelerate continually.