Step By Step Building The Top Magnetic Generator Videos

The following videos show a step by step on how to build the magnet generator project:

Video #1 – Preparing the Magnet Rotor Plate

The Magnetic Energy Generator is based on two metal Magnet Rotor Disks made of steel.
On this disk, there are already drilled four holes + 1 in the center.
These holes are required to mount the rotor to the hub.
Draw two lines connecting two opposite holes and then add two more lines, going through the central hole.
This way you will divide the disk into eight equal parts.
Next, you’ll need to draw an inner circle on the disk.
Next, drill eight holes in the disk each in the same distance from each other.
Finally for this stage, you need to use a screw tap to tap the holes.

Video #2 – Preparing the Faceplate Paper

Take a piece of paper and place the disk on it.
Then cut the paper along the outer line of the disk.
Next, place the paper on the disk.
Place eight magnets on the paper at an equal distance.
Then cut the paper again along the outer line of the magnets.
Next, you make marks on the paper for the disk holes and make incisions with a chisel.
Then you will place a ring on the paper and cut the paper along the outer line of it. The paper is ready.

Video #3 – Constructing the Magnet Rotor Disk

Take the disk and place a paper on it.
Place the outer mold on them.
Insert screws on the outer mold and on the disk holes.
Place a ring on the disk and fixed it with glue.
Next, place the eight magnets on the disk at equal distance.
Fill in the gap with resin.
Place the paper between faceplate and stack.
Put the coil along the outer lines of the magnets.
Wait for the resin to dry, and then clean the plate, remove the ring, and the screws from the outer mold.

Video #4 – Assembling it All to be Magnet Motor

Place the two magnet rotor disks side by side.
Insert the bearing hub between the two disks.
The permanent magnet motor is ready to use now.

As the magnets push and pull each other depending on their positions of north and south to each other, the disks will rotate and accelerate continually.

In Conclusion

So that’s it!
If You Want to Build Your Own Magnetic Generator…
and Save Thousands of Dollars on Your Electric Bill,

Go Ahead And…

Click Here to Get the Magnetic Generator Plans!

About the Author

You may also like...